Monday, October 19, 2015

Rocket TinkerCad

This rocket is the first design I have made on TinkerCad without any instructions from them and I found it pretty easy. Below are the steps I did to make it.

Step 1: I first drag the a cylinder shape onto the middle of the platform.
Step 2: Then I re-sized it bigger.
Step 3: After I dragged a paraboloid, then I put it on top of the cylinder.
Step 4: Then finally I dragged a wedge shape, re-sized it so it would fit like a fin. Then copied and pasted so there are 4.

This is the final result:


No comments:

Post a Comment